Repair the FLAGG!
This is a kit of 3D printed tabs to repair the "Long Elevator Support" and the two (2) "Elevator Side Supports."
Included: Four (4) regular tabs and four (4) hook tabs. Two regular tabs are to be attached to the top of the Long Elevator Support and will insert into the holes of the flight deck. The other two regular tabs are attached to the top of the Elevator Side Supports (1 on each) and will insert into the holes of the flight deck. The four (4) hook tabs are placed on the side of each Elevator Side Support (2 on each) and will insert into the slots of the Long Elevator Support.
Not Included: E6000 glue. You will need a strong adhesive intended for plastic. You can find this at a hobby or craft store. The USS Flagg pieces shown in the photos are not included, they are for illustrative purposes.
This is a kit of 3D printed tabs to repair the "Long Elevator Support" and the two (2) "Elevator Side Supports."
Included: Four (4) regular tabs and four (4) hook tabs. Two regular tabs are to be attached to the top of the Long Elevator Support and will insert into the holes of the flight deck. The other two regular tabs are attached to the top of the Elevator Side Supports (1 on each) and will insert into the holes of the flight deck. The four (4) hook tabs are placed on the side of each Elevator Side Support (2 on each) and will insert into the slots of the Long Elevator Support.
Not Included: E6000 glue. You will need a strong adhesive intended for plastic. You can find this at a hobby or craft store. The USS Flagg pieces shown in the photos are not included, they are for illustrative purposes.