USS Flagg Mast 99 Cap & 99 Sleeve
Repair the Flagg!
These are custom 3D printed mast attachments designed specifically for the USS Flagg mast. The cap and sleeve both have a custom "99" on them. The "99 Cap" is designed with an "X" slot to hold the upper section of the mast together with straight alignment. The "99 Sleeve" slides over the lower section of the mast to provide additional stability. The Flagg mast is NOT included.
Q1: Will this fix a broken mast?
I cannot guarantee that it will "fix" your broken mast. There are certain stress points on the mast that are prone to break. Depending on where the break occurs, the sleeve can reinforce the mast without the need for glue. You can decide if glue is necessary.
Q2: Can I use this on my mast even if it isn't broken?
Yes. The cap and sleeve actually reinforce the mast and can protect it from damage.
Q3: Is it easy to install?
Yes. Simply align the "X" on the bottom of the "99 Cap" with the upper section of the mast. DO NOT force and risk further damage to the mast. It should be a snug fit without forcing the cap to fit. Likewise, the "99 Sleeve" should slide from the bottom over the lower section of the mast. DO NOT force and risk further damage to the mast. It should be a snug fit without forcing the sleeve.